- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm trying to access my router to upgrade to WPA2 and disable Upnp for my FTP client and for some reason the router will not accept my username and password for the router. Currently the stock WEP settings are in place. Need to get this done because I need to use FTP to upload my website to my domain online. Any ideas? I've tried the username and password several times, both as standalone, and in the form of email.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Try the username of admin, and the password of your router's Serial Number. Failing that, give the Rev. F a Factory Reset, log into the router at the same IP address, and finally, set a new password for the router. The default login, if prompted, is admin/password respectively.
Another good reason to use WPA2: The Rev. F is a Wireless N router, a Draft N that runs at 65Mbps at least. To comply with the N spec and to also get N speeds, you need to use WPA2 with AES Encryption. Use anything else, and you will not get the speeds you're looking for.