- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just got FIOS installed and want to adjust the DVR analog stereo out volume on the box with the remote's volume and mute buttons, and not have to go through the menu every time. This wasn't a problem with RCN and their older Motorola DVR.
I tried the 955 code and it didn't work:
Any suggestions?
The Motorola QIP7232 DVR is running version 1.8 firmware.
My setup uses an Epson 8100 1080p projector connected via HDMI. The analog DVR outs go to a input switch box, then to my Parasound 5 channel amp. Surrounds/center are directly connected to my Oppo Blu-Ray analog outs, with the front channels going through the switch box. Simpler, cheaper, and better sounding than home theatre preamp. Less annoying changing channels too with waiting for the 5.1 audio to sync.
Thanks for any help.
Solved! Go to Correct Answer
Correct answers
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oops, retried directions on remote pamphlet. They worked.
1. OK +2
2. 955 after it blinks twice
3.STB after twice blink
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oops, retried directions on remote pamphlet. They worked.
1. OK +2
2. 955 after it blinks twice
3.STB after twice blink