×

Switch Account

Access Points not working with new New Tri-band 4x4 Router

Reply
Highlighted
Contributor
Contributor
Posts: 1
Registered: ‎07-15-2020

Access Points not working with new New Tri-band 4x4 Router

Message 1 of 2
(82 Views)

I had an old Fios Router (Fios Quantum Gateway)

and I recently got the New Tri-band 4x4 Router that is supposed to be faster.  My house has two TrendNet  (Model TEW-821DAO/A) units that operate as Access Points.  The Access Points were working fine until I installed the New Tri-band 4x4 Router.  My house has six levels so I need the Tri-band 4x4 Router for the first two floors and the two TrendNet units for the other 4 floors.  I would appreciate any thoughts on what has happened?  Thanks. 

1 REPLY 1
Highlighted
Gold Contributor VII
Gold Contributor VII
Posts: 5,026
Registered: ‎10-18-2016

Re: Access Points not working with new New Tri-band 4x4 Router

Message 2 of 2
(62 Views)

Off hand I would say you would have to do the setup over again.

you may try making the SSID the same as the last routers name, but I would say it is best to set the other routers up again in access point mode.

 

dont turn on any self organizing network (SON) and then test to see if it now functions.

in my opinion fios routers are junk. You can buy personal routers that have more coverage. 

How-To Videos
 
The following videos were produced by users like you!
   
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.
Covid19


Browse Categories
Categories:
Posts

Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.