- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
After my FiOS installer left, I tried to access the router's settings page with a few different logins. After none of the ones I found online worked, I did a hard reset of the device. I'm wondering if there are any VZ recommended settings (ie: QoS settings for my STB) that I should be sure to re-enter now that it has been hard reset. Can anyone give guidance on this? Thanks!
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I do not recall my installer making any changes to the Router out of the box, except top change the password which is required.
I have since had to do a hard reset and everything works just fine with no changes.
All of the settings for the STBs should be fine. I did change mine to give them static TPC/IP Addresses so that I would not have them changing on me and temporarily loosing remote DVR Capabilities.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Brian, how do you get the STB's to have a static address? On ocassion I cannot access the remote DVR and after I reboot the actiontec it seems to work but that is a useless solution when you want to record something and are not home.
Thanks, Jim
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@jumpin68ny wrote:Brian, how do you get the STB's to have a static address? On ocassion I cannot access the remote DVR and after I reboot the actiontec it seems to work but that is a useless solution when you want to record something and are not home.
Thanks, Jim
I ran into something similar because the DVR would change it's TCP/IP Address and not udate the forwarding rule in my Router via UPNP. I was able to make my STB use a Static Address with a DHCP Reservation and then enabled and re-enabled the remote dvr feature on the STB to update the Forwarding Rule and it has been ok ever since.
To make the DHCP Reservation on the Actiontec:
- Select Advanced
- Select IPAddress Distribution
- Select ConnectionList
- Select the STB from the List and Edit
- Check off the Static Lease Box
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks Brian... I made the change!!!
Jim