- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Very strange. I plug back in my old Actiontech router and my ReadyNas is assigned a dynamic IP address. however, when I switch over to new Actiontech "N" router the device isn't displayed, and it can't be reached by ping.
when connected to the legacy Actiontech here is my connection info:
The Ipv4 address is 192.168.1.15 (receiving IP from dynamically)
subnet mask 255.255.255.0
status : Online / 100 Mbit / Full-Duplex
MTU : 1500
It is set to auto-negotiate.
Is there anything in this setup that gives way to concerns in connecting this device to the new "N" router?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
After swapping in the new N router, did you reboot the NAS so that it would request a DHCP lease from the new router?
Without doing so, the new router won't know anything about a DHCP lease that was on the old router.