- « Previous
-
- 1
- 2
- Next »
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
nothing such as that is listed on the cable, and this particular one is good for 100m before lose apparently, Should I edit any settings either on console or router?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Fair enough on the cable ti should say if it's UTP or STP before it shows that is it a cat 6A cable, nontheless. uyou have a good distance then.
Does your Ethernet cable run over any electircal lines and near any TVs?
I think you said you often do Factory resets of your router to try and fix you isses too?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Recently started doing factory resets, but was doing normal power cycles to clear cache's and what not. and no, the way I run my wire it runs into literally 0 interfence from any other electrical or any other power demanding entities.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
One other thing I could htink of that might help you is actually having your ONT rebooted.
Do you know where the BBU/Power Reserve for the ONT is located in your home?
If so you can manually reboot your ONT using that device.
Use Verizon | Battery Backup to detemine which one you have.
BBU
You can achieve this by pressing and holding the Alarm Slience button for 10-12 seconds.
Power Reserve
You can achieve this by pressing and holding the ONT Reset button for 10-15 seconds.
See if this helps any. Typically it is a last resort thing, but sometimes it helps. Another option as well is seeing if you have a different Ethernet cable you can run between the ONT and the router.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The ethernet chord running from the router to the ONT is a brand new cat 5e.. When I get back home from University classes I'll give your solution a try, if it does work many thanks and you'll get ur credit
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
OK, SO My BBU is in my basement and my ONT is outside my house
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
So Should I Reset the BBU as well as the ONT or just the ONT? thank you
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Just the BBU, it will actually reboot the ONT as a result of that action.
- « Previous
-
- 1
- 2
- Next »