Port Forwarding Issues, need help

[SpaceGhost1]

Hello,

I have the M1424wr Gen3 Rev 1 Verizon Router connected to My PC is a Dell with Windows Vista Home Premium.

I am trying to configure the router's port fowarding to an application on my laptop Toshiba Satellite, Windows 8 called BroadWave. I think I am configuring it right to allow the application to access the router. Attached are screen shots of what my current settings are like. I am going nuts trying to figure this out.

I think it may be because the router is blocking the port? Broadwave is asking to direct the port to my laptop IP address and port 88. I even tried the DMZ Host to enable it. BroadWave is still not configured to get access to the router. It will connect to the port if I input my laptop IP address to the nat/rule but then that blocks the laptop to get internet access.

Help would be much appreciated! Thank you

This is the BroadWave settings...and configuring message I get.

These are my port forwarding settings on my PC.

These are my static nat rule settings on my PC. These settings let Broadwave connect to the port but then my internet on my laptop will stop working.

Thank you!

[Anti-Phish1]

You DON'T want to use static NAT unless you have multiple static WAN IP addresses assigned by VZ.

Otherwise, your port forward rules for 192.168.1.3 look fine.

[mfizzy]

The software supports UPnP and should be able to config ports for you. Did you click on run web routing and test wizzard?