×

Switch Account

Syslog configuration

Reply
Highlighted
Contributor
Contributor
Posts: 1
Registered: ‎06-26-2015

Syslog configuration

Message 1 of 4
(984 Views)

Within the router I've enabled both system and security logging to a remote host (my Windows system). However, when I run Wireshark I am not seeing any traffic from the router to my system via port 514.  Is there a setting I am missing or might have mis-configured?

 

Thx

3 REPLIES 3
Highlighted
Copper Contributor
Copper Contributor
Posts: 6
Registered: ‎05-03-2010

Re: Syslog configuration

Message 2 of 4
(433 Views)

I don't think anyone reads these posts ... much less answers them!

 

Sorry!

Highlighted
Platinum Contributor III Platinum Contributor III
Platinum Contributor III
Posts: 7,826
Registered: ‎11-04-2008

Re: Syslog configuration

Message 3 of 4
(431 Views)

This is mainly a peer to peer support forum.

Doubtful that anyone will go back to answer a post that is over 4 years old.

 


If a forum member gives an answer you like, give them the Kudos they deserve. If a member gives you the answer to your question, mark the answer as Accepted Solution so others can see the solution to the problem.
Highlighted
Moderator Moderator
Moderator
Posts: 1,836
Registered: ‎07-06-2016

Re: Syslog configuration

Message 4 of 4
(423 Views)

In order to keep discussion on the community current, this topic has been locked to prevent new replies. If you have a similar question or issue that you wish to discuss, then please feel free to post a new message on the most relevant board. Thanks!

How-To Videos
 
The following videos were produced by users like you!
   
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.
Covid19


Browse Categories
Categories:
Posts

Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.