An Accepted Solution is available for this post.
Trying to setup VLAN to access 2nd subnet
RonBo1
Newbie
‎06-13-2015 01:27 PM

Results so far:  By adding VLAN and route, when I enter 192.168.10.1, I get the Verizon Router login page (same as if I entered 192.168.1.1) instead of the browser page on the Tivo N-Adapter (192.168.10.1).  Somehow, when setting up the VLAN and route below, I've pointed 192.168.10.1 to 192.168.1.1. So the http://192.168.10.1 traffic on port 80 doesn't make it to the Tivo N-Adapter setup wizard but the traffic is directed to the router port 80 instead.  Help!

The hardware

Laptop: 192.168.1.102 running Windows 8.1 Pro

Mask: 255.255.255.0

Gateway: 192.168.1.1

Tivo N-Adapter: 192.168.10.1

      (want to access multiple device plugged into 1 port on router using laptop browser)

ActionTec MI424WR Rev. I: 192.168.1.1

VLAN1 setup on Actiontec Router

Network (Home/Office) VLAN 1

ip: 192.168.10.1

mask: 255.255.255.0

Ip address distribution: disabled

Network (Home/Office) via "My Network" / "Network (Home/Office)" "Ethernet/Coax"

   Ethernet/Coax

   Port 5 assigned to VLAN (PVID 1)

   Ingress Ploicy: Untagged (Do Not Add VLAN Header)  <- Tried both tagged & untagged

   Egress Policy: Untagged (Remove VLAN Header)

Advanced/Routing entry in Table

   192.168.10.0   192.168.1.1   255.255.254.0  Metric 0  (applied)

On laptop

ROUTE ADD 192.168.10.0 MASK 255.255.254.0 192.168.1.1

0 Likes
Reply