- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Followed exactly the Basic Instructions that came with the WCB3000N Wireless Ethernet Coax Bridge
Power Green
Coax Green
2.4G Green blinks for a while then solid again
5G Green
WPS Button blinks RED IS THIS NORMAL ?....IF NOT …HOW DO I FIX IT ?
From my M1424WR Rev F
Device Information for WCB3000N
Network Connection Bridge
Lease Type Dynamic
Status Active
Remote Access Enabled
IP & MAC Addresses ASSIGNED
WiFi signal strength now SEEMS to give me better coverage than before.
Solved! Go to Correct Answer
Correct answers
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No, it is not normal for the WPS light top be red. However, this should not cause you any problems becuase WPS is used only to connect a new device "automatically"; i. e., without requiring the user to enter the network password.
In your case, since the WCB3000N was added to your existing network with all your devices already aware of and connected to it, WPS has no real use for you.
You might check if something has caused teh WPS button to be stuck in the depressed position. If not I'd expect the red light to go green after the WPS function times out due to no network device answering it.
It is not surprising that you have experienced improved wireless performance with the WCB3000N active. It not only provides an additional wireless access point, but it is a dual band device - as opposed to your router being single bad - and this means it can support double of wireless throughput of your router.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No, it is not normal for the WPS light top be red. However, this should not cause you any problems becuase WPS is used only to connect a new device "automatically"; i. e., without requiring the user to enter the network password.
In your case, since the WCB3000N was added to your existing network with all your devices already aware of and connected to it, WPS has no real use for you.
You might check if something has caused teh WPS button to be stuck in the depressed position. If not I'd expect the red light to go green after the WPS function times out due to no network device answering it.
It is not surprising that you have experienced improved wireless performance with the WCB3000N active. It not only provides an additional wireless access point, but it is a dual band device - as opposed to your router being single bad - and this means it can support double of wireless throughput of your router.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Since I posted...WPS RED BUTTON IS NOW SOLID GREEN
DID NOT DO ANYTHING TO ACCOMPLISH THIS
HAPPY NEW YEAR TO YOU AND YOURS.