- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have enabled and disabled and enabled the alert display and have reset the STB and still no display. Happed at the same time on my two DVR's.
Any ideas anyone?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Just realized my caller ID, too, isn't displaying. Thought I'd bump up this thread in the hopes that someone has a suggestion or at least an explanation.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mine also stopped a few days ago although the receiver states it is enabled.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Had the same problem
It worked fine for a couple of weeks then it stopped
I disabled/enabled and it worked again
then it stopped again and never returned
I called tech support and apparantly my router and tv were not communicating properly so he reset both the router and STB and it's worked perfect for 3 days now.
You might just have to call, I was only on hold a few minutes and the tech was very helpful.
Good luck