An Accepted Solution is available for this post.
Cisco 435 and IR
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just had my Cisco Multi room 435 dvr installed. My big issue is using it with a IR blaster. If I hook up a blaster that is connected to my Global Cache which is being used in conjunction with IRULE, the blaster goes off , but the DVR does not perform. I have tried to move the blaster to several locations in front of the DVR where the IR sensor is located, but no luck. I cannot connect directly to the IR slot in the back because the signal is not coming from a direct IR source but rather from my Global Cache. Any suggestions?