×

Switch Account

DCT-700 Digital Adapter - no channel number displayed

DCT-700 Digital Adapter - no channel number displayed

Reply
Contributor frogman95
Contributor
Posts: 1
Registered: ‎08-16-2009
Message 1 of 3
(4,263 Views)

I just installed a DCT-700 Digital Adapter to replace a defective one. I have everything working except no channel number is displayed in the lower left corner when changing channels. Is this something that can be turned on with the remote?

 

thanks

2 REPLIES 2
Platinum Contributor I Platinum Contributor I
Platinum Contributor I
Posts: 5,175
Registered: ‎08-05-2008
Message 2 of 3
(4,267 Views)

That did not happen on mine, but I have seen posts from folks where it has. I believe their solution has been to remove electrical power and plug it back in; sometimes it apparently takes several times for it to work.

 

__________________________________
Justin
Verizon FiOS TV, Internet, and phone
QIP6416, IMG 1.6.2, Build 08.58
Keller, TX 76248

Bronze Contributor II
Bronze Contributor II
Posts: 280
Registered: ‎01-30-2009
Message 3 of 3
(4,206 Views)
I agree with Justin.  I noticed this too, then the channel numbers appeared the next day.  give it a week.
You've got to be very careful if you don't know where you're going, because you might not get there. --Yogi Berra
How-To Videos
 
The following videos were produced by users like you!
   
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.



Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.