Accessibility Resource Center Skip to main content
Get it fast with In-store & curbside pickup or same day delivery.

DVI Error

Reply
ancampbellee
Contributor
Contributor
Posts: 1
Registered: ‎02-18-2010

DVI Error

Message 1 of 5
(7,708 Views)

I've read the other posts for the DVI error, but none seem to offer solutions besides going to component cables.  Has any solution been presented?  I'm getting that error.  Any suggestions?

4 REPLIES 4
Keyboards
Gold Contributor VII
Gold Contributor VII
Posts: 2,323
Registered: ‎08-05-2008

Re: DVI Error

Message 2 of 5
(7,666 Views)

Unless the IMG 1.7 update fixed the problem, the only other consistent solution is still component canles.  I know that's not the answer you were looking for, but it is what it is.

If a forum member gives an answer you like, give them the Kudos they deserve. If a member gives you the answer to your question, mark the answer as Accepted Solution so others can see the solution to the problem.
lesinj
Contributor
Contributor
Posts: 1
Registered: ‎03-10-2010

Re: DVI Error

Message 3 of 5
(7,402 Views)

I still get he DVI error using component cables.  Does that mean my box is bad?

Keyboards
Gold Contributor VII
Gold Contributor VII
Posts: 2,323
Registered: ‎08-05-2008

Re: DVI Error

Message 4 of 5
(7,391 Views)

 


@lesinj wrote:

I still get he DVI error using component cables.  Does that mean my box is bad?


 

Did you disconnect the HDMI cable?  If it is still plugged in (even though not the active input) you may still see the error.

 

If a forum member gives an answer you like, give them the Kudos they deserve. If a member gives you the answer to your question, mark the answer as Accepted Solution so others can see the solution to the problem.
Hubrisnxs
Platinum Contributor III
Platinum Contributor III
Posts: 5,881
Registered: ‎07-22-2009

Re: DVI Error

Message 5 of 5
(7,353 Views)

it wouldn't be the stb or box that is bad, but either the cable or that hdcp handshake problem (which there aren't good work arounds for besides going component)

 

Keep in mind though there are a lot of people that get DVI and are still able to watch tv normally without a problem, so just because you see dvi, it doesn't neccessarily mean anything.   If you're unable to watch tv because of it then, you'll want to reseat the hdmi cable first, see if your picture comes back, change hdmi ports on the tv, and see if it comes back.   if it doesn't  then you might be a perfect candidate to move over to component cables.   the 1.7 upgrade fixed a number of hdmi issues for a lot of customers, but not 100% of them, so you can check with the AVS forums for your particular tv set to make sure there isn't a firmware upgrade that you should be taking advantage of, but other than that, you would have to wait for 1.8 to see if it corrects your issue.   remember your manufacturer puts out similiar fixes too, so check with them as well.

How-To Videos
 
The following videos were produced by users like you!
   
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.
Have a spare Fios-G1100?Learn how to bridge it into your network
Get Started


Covid19

Browse Categories
Categories:
Posts

Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.