- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I've successfully added an external hard drive to my Cisco 435 DVR, but now I seem to only be able to record one show at a time. I've tried the problem fixer, to no avail.
It tried to record, and it asks me what to do, and I say record both shows, but it stops recording after 1 second.
Anyone else have a problem like this or suggestions?
Thanks
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There are a couple auto fixers
if you hit dvr there is a dvr auto fixer did you do that?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, DVR MR autofixer.
Since I had two shows to record Friday night at the same time, I ejected the drive and unplugged it all. Plugging it all in again and restarting seems to have corrected the problem though - At least I can record two shows at the same time again.
I think I had a 1 or possibly 2 shows on the external drive previously. Is there a way to get them back on the list, as they are no longer displaying in the list of recordings, yet the status now says that 1% of the drive is used, as opposed to yesterday where it never budged off of 0%.
Thanks