An Accepted Solution is available for this post.
Grey Screen then message "Terminal locked enter technical code and press select"
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The DVR just stops and then we get a grey screen and the message " Terminal locked enter technical code and press select" it was doing this once in a while and as of today every 10 minutes.
Any suggestions would be appreciated.
An Accepted Solution is available for this post.
Re: Grey Screen then message "Terminal locked enter technical code and press select"
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Pull the plug on the STB. This may reset it properly.