Accessibility Resource Center Skip to main content
Get it fast with In-Store & Curbside Pickup or same day delivery.

IPC1100 Setup using 720p projector component cable

Reply
kirkm
Contributor
Contributor
Posts: 1
Registered: ‎03-22-2015

IPC1100 Setup using 720p projector component cable

Message 1 of 2
(571 Views)

I am updating to quantum TV and having issues getting a projector to work with the IPC1100.  Initial setup went fine just like the HDMI tvs but once it gets to the watch TV at the end the video output disappears.  If I unplug the IPC1100 and it goes through initialization I see the various splash screens and see a couple seconds of TV and then it disappears again.  If I run a HDMI cable to the projector to appears to work fine. However I dont have a permanent HDMI cable to the projector and dont want to run one. The IPC1100 appears to stop sending output to the component cable. How do I configure it to use the component output? I have set the output resolution to 720p which is the best configuration for the projector.  Neither 480i, 720p or 1080i work.

 

 

1 REPLY 1
CRobGauth
Platinum Contributor III Platinum Contributor III
Platinum Contributor III
Posts: 7,978
Registered: ‎11-04-2008

Re: IPC1100 Setup using 720p projector component cable

Message 2 of 2
(545 Views)

So are you trying to run HDMI and component at the same time (one to projector and one to TV)?


If a forum member gives an answer you like, give them the Kudos they deserve. If a member gives you the answer to your question, mark the answer as Accepted Solution so others can see the solution to the problem.
How-To Videos
 
The following videos were produced by users like you!
   
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.
Have a spare Fios-G1100?Learn how to bridge it into your network
Get Started


Covid19

Browse Categories
Categories:
Posts

Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.
Modal Dialogue Title