- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have HD (7216) and SD (7100) stbs. Both models have a 1/8" jack labelled "ir remote input" that doesn't seem to work. I've got some Xantech receivers lying around, tried them, and none work. So, I'm guessing it must be one of three things:
1. The ir remote input is not enabled in software
2. The ir remote input is not connected to the board.
3. I have an ir receiver that is the wrong frequency. I don't even know if this is a possiblity, but I thought I'd include it.
I can't find any information out about this input, and was hoping someone here could set me straight.
Solved! Go to Correct Answer
Correct answers
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Peecee
The Ir Remote input on the back of the box is currently not enabled that is why it will not work.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Peecee
The Ir Remote input on the back of the box is currently not enabled that is why it will not work.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Good. I guess there's no information on if (or when) it will be enabled?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content