- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CapnTrips wrote:
Direct connection of the signal from antenna or cable to your TV does NOT "prove" thath the problem is exclusively with the STB. It demonstrates NOTHING relative to a possible problem with HDMI transmission reception/handshake issues between your TVand STB. These Motorola STBs seem to work pretty well for many customers. There are, however, more than a few posts in these fora indicating that there are some problems negotiating HDMI hadnshakes between the STBs and certain TVs - mostly Sony's and Samsungs. Additionally, there are more than a few reports that even if you switch to component video cables (the red, blue, and green ones), and therefore eliminate HDMI as the problem, some still have video dropouts. In those cases, it seems likely that the problem lies with the STB. I have read somewhere in these fora that there is supposedly a software/firmware update that is imminent for the STBs that seeks to address this issue.
That said, I just wanted to point out that none of your evidence "proves" that the issue is with the STB. In particular, the HDMI handshake issues can just as easily lie with the TV as with the STB, even if you have other HDMI sources that work.
Thank you for explaining about the HDMI handshake. As I noted once before, I am unskilled in these matters, and I just want to be able to watch my TV without interruption. If another device is attached to the same TV by HDMI inputs (XBox, Blu-Ray), and it works just fine, is that b/c the "handshake" is different in some way?
Thanks
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
"Thank you for explaining about the HDMI handshake. As I noted once before, I am unskilled in these matters, and I just want to be able to watch my TV without interruption. If another device is attached to the same TV by HDMI inputs (XBox, Blu-Ray), and it works just fine, is that b/c the "handshake" is different in some way?
Thanks "
Yes, that handshake is different. It's not on the STB..lol
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sony KDL-46v5100: Gave up and put back on the component cables as the loss of signal has gotten worse and now my picture goes black with audio still functioning. The consensus among 4 viewers is the picture on component is inferior to the picture from HDMI. For all those who believe the output is always the same because both support 1080i, keep on believing they are the same except not in my house.
I have read many comments stating Verizon is allegedly working on a solution to this problem. In the interim, my picture is not as good as Comcast's and that sucks because Comcast's was not as good as DISH's.
Verizon: Please publish an official statement on this issue and an estimate of when it will be solved. I am not talking about one of the Verizon employees saying they heard it was going to happen. I am requesting a published statement. I am with Verizon television service for the quality of picture - not because of their superlative HD DVR or their fabulous IMG with all the program detail anyone could want. Last point: it stills thrills me to see the "solved" icon for this thread
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@Humble wrote:Last point: it stills thrills me to see the "solved" icon for this thread
Several posters have commented about the "inaccuracy" of the "Solved" icon in this thread. Evidently, the original poster (mjdjr) has had HIS problem solved, and marked it as such. If you believe that his problem is NOT solved, then perhaps you should speak to him about UNmarking the thread.
On the other hand, if YOUR problem is not solved yet, well it is NOT the subject of this thread. If you want to separate your problem from the original poster's, then start a new thread with YOUR problem, and it won't be marked "solved" until you decide it is.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you believe that the "Solved" marking somehow inhibits your ability to get your problem looked at, so be it.
I agree that Verizon Tech Support is far below any reasonably expectable standard, but that "Solved" annotation in a peer-to-peer forum doesn't make it any better or worse.
I'm done on this topic, since I certainly do NOT know how to solve your problem.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I cut the copperline years ago, people are sick of me showing them my 'laser' in the back yard.
LONG TIME LurkerFIRST TIME Poster.
MY BOX IS NOW FINE!!
This was still anissue. Sony XBR4 works fine on everyHDMI source/input. TV Rock SOLID. Newstb problems got a lot worse when theyintroduced new "facebook type" widgets.
This issue is beingactively followed on the FiosTV Tech Assist: "HDMI Handshake" thread.
http://forums.verizon.com/vrzn/board/message?board.id=FiOS_TV&thread.id=12057
I highly recommend unplugging your wirelessrouter and your set-top-box. Re-plug the router first and then the stb. This gives you the best chance of getting thelatest patch. I did this (rebooting) andthe drop outs have seem to have disappeared. I don't say I solved the thing, but my viewing experience has vastlyimproved. Best picture around when it stays on…..three days now and no dropouts.