Accessibility Resource Center Skip to main content
Have a phone you love? Get up to $500 when you switch and bring your phone.

Quantum router + 3 TV splitter setup

Reply
taboni
Contributor
Contributor
Posts: 2
Registered: ‎12-08-2011

Quantum router + 3 TV splitter setup

Message 1 of 2
(972 Views)

I have an old home with several runs of coax that I want to optimize/clean up.  What is the recommended splitter setup for a Quantum router plus 4 TVs? I currently have a cable from the ONT coming in to an unbalanced 3 way splitter with 3.5db leg going to the router. One of the 7db legs goes directly to a media client. The other 7db leg goes to a splitter which feeds the VMS plus 2 more media clients.  

 

I don't think this is optimal as I am splitting a 7db leg further down the line....any suggestions? Should I feed the router with a 7db leg from the ONT instead of 3.5db? Confused.....

1 REPLY 1
CRobGauth
Platinum Contributor III Platinum Contributor III
Platinum Contributor III
Posts: 7,978
Registered: ‎11-04-2008

Re: Quantum router + 3 TV splitter setup

Message 2 of 2
(957 Views)

A lot depends on cable length and type.

I would put the shortest cable on a 7db leg and make sure the longest is on the 3.5 db side.

that assumes all cable types are the same.

if it is not rg6, I would try and replace any that you can with it.


If a forum member gives an answer you like, give them the Kudos they deserve. If a member gives you the answer to your question, mark the answer as Accepted Solution so others can see the solution to the problem.
How-To Videos
 
The following videos were produced by users like you!
   
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.
Have a spare Fios-G1100?Learn how to bridge it into your network
Get Started


Covid19

Browse Categories
Categories:
Posts

Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.
Modal Dialogue Title