An Accepted Solution is available for this post.
STB Does Not Always Display Clock When Set
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
My set top boxes seem to display the channel rather than the time even when I set the option to clock in the setup menu. I sometimes have to select clock and then channel and back to clock again before this preference works again. Then the after a while, the clock goes back to channel and I wasn't even changing channels. I realize that when changing channels that that should display but lately it does not go back to the time after a few seconds like it used to. Does anyone else experience this?
2 Replies
An Accepted Solution is available for this post.
Re: STB Does Not Always Display Clock When Set
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
See http://forums.verizon.com/vrzn/board/message?board.id=FiOS_TV&thread.id=4033
Try powercycling the cable box and see if it resolves the issue.
An Accepted Solution is available for this post.
Re: STB Does Not Always Display Clock When Set
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have cycled power and that helps but it seems I shouldn't have to. I should dedicate one power strip to the Verizon FIOS equipment since that is the cure all for everything on a daily basis. When it doesn't work right ....cycle power or unplug it or reboot etc........I can't wait for the next software "upgrade"!