×

Switch Account

The mute button on my FioS remote does not work my Vizio TV

Reply
Highlighted
Contributor
Contributor
Posts: 2
Registered: ‎08-26-2009

The mute button on my FioS remote does not work my Vizio TV

Message 1 of 4
(18,124 Views)

I have a Vizio 32" High Def TV. I entered all the programming numbers and none worked for my TV so I used the alternate metghod of programming my remote to my TV and the MUTE button will not work my TV. Any advice?

3 REPLIES 3
Highlighted
Gold Contributor VII Gold Contributor VII
Gold Contributor VII
Posts: 1,796
Registered: ‎08-06-2008

Re: The mute button on my FioS remote does not work my Vizio TV

Message 2 of 4
(18,083 Views)

Sometimes with Vizio TVs if you press the TV button at the top and the A/V button on the bottom of the remote it will mute the TV.

Highlighted
Silver Contributor II
Silver Contributor II
Posts: 280
Registered: ‎01-30-2009

Re: The mute button on my FioS remote does not work my Vizio TV

Message 3 of 4
(18,071 Views)

try a different code, there is another thread here where someone found a few good ones.

 

it works for my vizio.

You've got to be very careful if you don't know where you're going, because you might not get there. --Yogi Berra
Highlighted
Employee Emeritus Employee Emeritus
Employee Emeritus
Posts: 171
Registered: ‎07-10-2009

Re: The mute button on my FioS remote does not work my Vizio TV

Message 4 of 4
(18,068 Views)

Reset remote to factory defaults
All previous programming will be lost 1) Press and hold the STB key. 2) While holding down the STB key, press OK. 3) Release both keys. The Devices Keys will blink twice. 4) press 9-0-0. The STB key will blink 3 times to indicate sucess in programming.

 

Program TV remote code

 

Press and hold the TV device key. While holding the TV key, press the OK key.  Release both keys at once. The four device keys will blink twice.  Enter the four-digit code (see below). After a short delay, the TV key will blink three times.  Test new device code by pressing POWER. If TV responds (turns off), the device configuration is successful. If device does not respond, then repeat steps 2-4 with the next code in the list. If the remote does not recognize the code, the LED will turn off.

 

1292, 0891, 0912, 1783

Joe D
Verizon Telecom
Fiber Solution Center


Notice: Content posted by Verizon employees is meant to be informational and does not supercede or change the Verizon Forums User Guidelines or Terms or Service, or your Customer Agreement Terms and Conditions or Plan.Follow us on Twitter™!

How-To Videos
 
The following videos were produced by users like you!
   
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.
Covid19


Browse Categories
Categories:
Posts

Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.