- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have my DVR registered to be remotely accessible. I have been able to access it remotely in the past. But now when I log in and try to access my favorites or the DVR I just get a message saying my STB could not be accessed or the accessing icon comes up and just spins and spins forever. Is there an easy fix for this or do I need to get on the phone?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
reboot the DVR, reboot the PC, reboot the router.....
If need be, reset the router with a paperclip or pen in the reset hole on the back of the router for 15 seconds
if still not working, contact tech support
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks. I actually just replaced my router because the old one was having some wireless issues, so maybe that is the problem?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
probably not...but anything is possible
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@glennauve wrote:Thanks. I actually just replaced my router because the old one was having some wireless issues, so maybe that is the problem?
Was the router replaced by Verizon or did you use anotehr router that you already had ?
The remote DVR process requires a Port Forwarding Rule that wiill get created in a Verizon Router but may not be created in a non Verizon Router.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I ran into something similar because the DVR would change it's TCP/IP Address and not udate the forwarding rule in my Router via UPNP. I was able to make my STB use a Static Address with a DHCP Reservation and then enabled and re-enabled teh remote dvr feature on the STB to update the Forwarding Rule and it has been ok ever since.
To make the DHCP Reservation on the Actiontec:
- Select Advanced
- Select IPAddress Distribution
- Select ConnectionList
- Select the STB from the List and Edit
- Check off the Static Lease Box