×

Switch Account

DSL Jack wiring

Reply
Contributor larryrow
Contributor
Posts: 2
Registered: ‎08-12-2013
Message 1 of 2
(711 Views)

I have several phone jacks in my home that have dial tone, but only one jack (call it Jack A) with DSL signal. That jack has blue/white and white/blue wires coming directly from the NID (also orange/white and white/orange that are not connected). The jack port is large enough to accept an ethernet cable but also takes my phone/dsl cable for my dsl router.

 

The Jack (call it Jack B) I would like to have DSL on is Red/Green/Yellow/Black wiring. Right now the red/green are hooked to the NID and it has dial tone. I figured I could swap the wiring on jacks A and B to get DSL into jack B, but it did not work.

 

Questions:

Will I be able to get DSL on Jack B, and if so will it perform poorly because of style/age of jack/cable?

How do I get DSL on jack B? Can I rewire this mess or do I need to run a new wire through the wall?

 

Thanks!

1 REPLY 1
Contributor larryrow
Contributor
Posts: 2
Registered: ‎08-12-2013
Message 2 of 2
(675 Views)

Nevermind, I figured it out. Tried connecting Jack B again and had some success, though connection speed and reliability was terrible. Not sure if it was my fault for not having wires connected well enough or the fault of the old wiring. I tore apart an ethernet cable and connected one of the pairs with much better results. Wired a cat5 through my wall and running nicely now.

How-To Videos
 
The following videos were produced by users like you!
   
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.


Browse Categories
Categories:
Posts

Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.