Ellipses...

Reply
Highlighted
Bronze Contributor I
Bronze Contributor I
Posts: 54
Registered: ‎04-25-2013

Ellipses...

Message 1 of 2
(5,382 Views)

Is there a way to see all the information in the guide for a program? Often times, regardless of which view I choose, it seems there are often lines that end with an elipse (...).  I suspect this means the line is too long and has been trunctaed, but it seems that there should be some way to see all the info. This bugs me the most when I'm looking at the cast, in "full info", and it ends with ... Cast is npt the only time this happens. I've seen it on other lines too. 

 

Thanks for your feedback, Eric

1 REPLY 1
Highlighted
Silver Contributor II
Silver Contributor II
Posts: 344
Registered: ‎11-09-2010

Re: Ellipses...

Message 2 of 2
(5,360 Views)

I'm assuming you're a Quantum user..

The Firmware for the Quantum was based on the old software that was in effect before that (and some other) features were introduced. Look for a near-term update to re-add and resolve those features.

How-To Videos
 
The following videos were produced by users like you!
   
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.
Covid19


Browse Categories
Categories:
Posts

Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.