Accessibility Resource Center Skip to main content
Get gifts fast with In-Store & Curbside Pickup or same-day delivery.

Port Forwarding and Static NAT

SOLVED
Reply
Highlighted
Copper Contributor
Copper Contributor
Posts: 5
Registered: ‎05-17-2009

Port Forwarding and Static NAT

Message 1 of 2
(12,465 Views)

I have 5 static IP Addresses, and I would like to run multiple webservers on my connection.  I have 3 servers that are able to run Apache via Linux and Windows ala WAMP.  I recently had my router replaced like last month, and I am using the following: MI424WR-GEN2 with firmware 20.9.0 and its fully updated.  I was using the MI424WR Rev D prior to it going bad, and I could host multiple web servers just fine with each public IP statically routed to the static LAN IP on my private network, however, after this switch I am only able to run 1 webserver on my 20 Megabit Synchornous FiOS Business Class Connection.  I have tried power cycling the modem, power cycling my computers and to no avail I cannot get the other servers to be contactable via outside my LAN.

 

What can I do to remedy this situation?

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Copper Contributor
Copper Contributor
Posts: 5
Registered: ‎05-17-2009

[SOLVED] Re: Port Forwarding and Static NAT

Message 2 of 2
(11,432 Views)

This has been fixed in the most recent router firmware. 

View solution in original post

1 REPLY 1
Highlighted
Copper Contributor
Copper Contributor
Posts: 5
Registered: ‎05-17-2009

[SOLVED] Re: Port Forwarding and Static NAT

Message 2 of 2
(11,433 Views)

This has been fixed in the most recent router firmware. 

View solution in original post

How-To Videos
 
The following videos were produced by users like you!
   
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.
Covid19


Browse Categories
Categories:
Posts

Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.