An Accepted Solution is available for this post.
Connecting a Projector to cable box
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm trying to figure out how to connect my sharp pg b10s notevision projector to my vms1100 multi room dvr. Thanks
2 Replies
An Accepted Solution is available for this post.
Re: Connecting a Projector to cable box
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Connect it just like you would a TV.
So depending on the projectors inputs, you can use HDMI, Component or composite.
An Accepted Solution is available for this post.
Re: Connecting a Projector to cable box
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I connected the Sharp AN-C3CP component connection cable in the back of the projector. I had to also purchase a "3-rca rgb rg-59/u component video splitter". I did this because the red,green, blue outlet was already occupied on the cable box.
I switched the projector to the appropriate input "input 1". However, the projector received no feed from any cable channels.