An Accepted Solution is available for this post.
Jump to solution.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there any way to convert the IP Address Allocation of a device from Static to DHCP on the Actiontec router?
Message Edited by Ezell on 01-10-2009 04:56 PM
Solved! Go to Correct Answer
1 Solution
Correct answers
An Accepted Solution is available for this post.
Jump to solution.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
your router 'assigns' the internal IP address of the devices attached to it when your router is set to be a DHCP Server, and your attached devices are set to be DHCP clients, and the attached devices are not set to use static IP addresses and do not have static IP addresses already put in them. BUT you do not set the devices attached to the router to be DHCP clients -on the router; you do it on the devices.
An Accepted Solution is available for this post.
Jump to solution.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
your router 'assigns' the internal IP address of the devices attached to it when your router is set to be a DHCP Server, and your attached devices are set to be DHCP clients, and the attached devices are not set to use static IP addresses and do not have static IP addresses already put in them. BUT you do not set the devices attached to the router to be DHCP clients -on the router; you do it on the devices.