An Accepted Solution is available for this post.
How to keep DHCP range from going back to default?
rags260z1
Newbie
‎07-25-2013 05:54 AM

Whenever I call Verizon for service such as activating a new STB, my DHCP distribution range will go back to factory settings. This is quite annoying as I have devices that require a certain IP segment. Is there a way to prevent anyone from resetting my router back to factory settings??

Joe

0 Likes
Reply
2 Replies
An Accepted Solution is available for this post.
Re: How to keep DHCP range from going back to default?
JOSEm441
Specialist - Level 2
‎07-25-2013 09:58 AM
I am not sure how to prevent the resettting but you could backup your router configuration by logging into the router, advanced - Config. file - save. Then restore it as needed.
0 Likes
Reply
An Accepted Solution is available for this post.
Re: How to keep DHCP range from going back to default?
Anti-Phish1
Master - Level 1
‎07-25-2013 04:03 PM

I don't know if you're trying to change the DHCP range used by the STBs.

The STBs have a reserved DHCP scope from 100 - 150.

You should avoid that range.

0 Likes
Reply