Accessibility Resource Center Skip to main content
Have a phone you love? Get up to $500 when you bring your phone.
end of navigation menu

Re: Is it possible to limit wifi bandwidth?

Silver Contributor V
Silver Contributor V
Posts: 668
Registered: ‎10-26-2008

Re: Is it possible to limit wifi bandwidth?

Message 2 of 3

You could restrict the available bandwidth in the advanced wireless setup for the router (it is buried under advanced security settings for wireless) to a fixed rate that ranges from 1 to 54mbps.  The problem is that would be the limit even if the desktop wasn't in use.


However I doubt you really need to do anything unless your laptop and router supports 802.11n. There are very few Verizon supplied routers out there that support 802.11n. So if you are using the Verizon supplied router, 802.11g is probably as fast as it gets. IN theory 802.11g can reach 54mbps, real world tends to be a lot lower.


Absent 802.11n support . It is pretty hard to get 802.11g (and impossible for 802.11b) to be much beyond about 10mbps bandwidth. 802.11n will support considerably higher data rates.


In my experience the the wireless hardware adapter on a laptop with 802.11g  is rarely configured with enough buffering to reach 54mbps, even if there were no other impediments. Usually there are plenty of other things to limit the wireless performance.


So the short answer is what you want is likely to happen anyway.

Posts: 3
Registered: ‎06-18-2011

Is it possible to limit wifi bandwidth?

Message 1 of 3

I have a main desktop computer connected to Fios 25/25 and a laptop that is connected via WiFi. Is it possible to limit the WiFi bandwidth when both computers are being used at the same time? I would like the desktop to have access to most of the bandwidth.

Employee Emeritus Employee Emeritus
Employee Emeritus
Posts: 3,216
Registered: ‎02-24-2011

Re: Is it possible to limit wifi bandwidth?

Message 3 of 3

Yes there is a way to prioritize traffic down to the specific device. When logged into the router, click the ADVANCED tab at the top. Then on the bottom left hand side go to QUALITY OF SERVICE. Click the ADD button to the right of WIRELESS ACCESS POINT RULES. The SOURCE and DESTINATION addresses should be selected to the computer you want to limit access to. Check the PRIORITY box and set the level to 0-LOW PRIORITY. Change the APPLY QOS ON to the value PACKETS. Lastly click APPLY. Now that one computer has the lowest priority so other devices on your network will get the preferred traffic.


**If someones post has helped you, please acknowledge their assistance by clicking the red thumbs up button to give them Kudos. If you are the original poster and any response gave you your answer, please mark the post that had the answer as the solution**

Notice: Content posted by Verizon employees is meant to be informational and does not supersede or change the Verizon Forums User Guidelines or Terms or Service, or your Customer Agreement Terms and Conditions or plan

How-To Videos
The following videos were produced by users like you!
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.
Have a spare Fios-G1100?Learn how to bridge it into your network
Get Started


Browse Categories

Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.
Modal Dialogue Title