An Accepted Solution is available for this post.
Syslog configuration
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Within the router I've enabled both system and security logging to a remote host (my Windows system). However, when I run Wireshark I am not seeing any traffic from the router to my system via port 514. Is there a setting I am missing or might have mis-configured?
Thx
3 Replies
An Accepted Solution is available for this post.
Re: Syslog configuration
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I don't think anyone reads these posts ... much less answers them!
Sorry!
An Accepted Solution is available for this post.
Re: Syslog configuration
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is mainly a peer to peer support forum.
Doubtful that anyone will go back to answer a post that is over 4 years old.
An Accepted Solution is available for this post.
Re: Syslog configuration
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In order to keep discussion on the community current, this topic has been locked to prevent new replies. If you have a similar question or issue that you wish to discuss, then please feel free to post a new message on the most relevant board. Thanks!