An Accepted Solution is available for this post.
WPS and FOSCAM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How do I turn on WPS for the Actiontec MI424WR Rev.1? OR has anybody sucessfully connected the FOSCAM FI9821W to the mentioned router? I have been not been successful in connecting the camera, a good friend of mine returned his because he was not able to connect it wirelessly. I will not give up!!! PLEASE HELP
4 Replies
An Accepted Solution is available for this post.
Re: WPS and FOSCAM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The Actiontec does not support WPS (even though it has a WPS button).
Do you have a spare router that support WPS? If so, configure the spare router with the same SSID and passphrase as the Actionbtec. Do your WPS with the spare router, then remove the spare router. The FOSCAM should connect to the Actiontec.
An Accepted Solution is available for this post.
Re: WPS and FOSCAM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can connect via an ethernet cable. THe manual shows how to setup the wireless for those without WPS.
An Accepted Solution is available for this post.
Re: WPS and FOSCAM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You are correct it does, but it does not work. Even with the support videos on the website it doesn't work.
An Accepted Solution is available for this post.
Re: WPS and FOSCAM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Excellent, I do have a spare Cisco router, I'll have to bust it out and see if I can do it. Thanks!