Accessibility Resource Center Skip to main content
Get up to $500 when you bring your phone. Plus, get the incredible iPhone 13 Pro on us. Online only. With select 5G Unlimited plans. Ends 12.5. Buy now
end of navigation menu

Discrete IR Codes for Motorola HD DVR QIP7216 and Pronto Remote

Posts: 1
Registered: ‎10-09-2010

Discrete IR Codes for Motorola HD DVR QIP7216 and Pronto Remote

Message 1 of 2



Cable box: Verizon Fios Motorola HD DVR QIP 7216
Remote: Pronto TSU3000

I am trying to learn the ir command but I am running into a snag.

The remote in question has four buttons across the top: DVD, AUX, TV, STB. In order to use the cable buttons I have to have the STB button selected.

So when I go to program the buttons, they are picking up the same hex code for all the buttons:

0000 006b 0000 0002 015d 0057 0013 0047

They are not picking up discrete ir's. I know there isn't one for the on/off. But the other buttons are picking up the same ir.

What am I doing wrong and what do I need to do so I can get my remote to work?




One other thing. When I am able to get what I think are discrete codes they do not work. Very frustrating.

Silver Contributor III
Silver Contributor III
Posts: 402
Registered: ‎07-07-2010

Re: Discrete IR Codes for Motorola HD DVR QIP7216 and Pronto Remote

Message 2 of 2

First of all, does the Verizon remote operate the DVR correctly? If not, it may have lost it's program or become defective in some way.


As for the Pronto learning:

Does the "Learning indiction" appear in the upper right corner of the screen after pressing the Learn and Learn Button icons and then the button you want to program?

Now, you are pressing the button on the Pronto first and the button on the Verizon remote after that, right? And holding the Verizon button down for at least a few seconds?


So, this is what I would expect the sequence to be: (Sorry if you already know all this)

1. Press the STB button on the Verizon remote.

On the Pronto,

  2. Press and hold the Pronto NG icon for as few seconds until the Tool menu appears

  3. Press the Learn icon

  4. Press the Learn button icon

  5. Select the device and page to be programmed

6. Put the two remotes head-to-head (pointing at each other)

7. Press the button on the Pronto you want to program

8. Quickly (within 5 seconds), press the button on the Verizon remote you want, for 1 second.

9. Watch for an "OK" display, meaning it was successful

10. Repeat steps 7-9 for each set of buttons to be learned.

Note: you must press a new button on the Pronto each time and you must press a new button on the Verizon each time.

11. When you are done, press the Done button



If in any case you do not have the manual, it is available on the web.


good luck




How-To Videos
The following videos were produced by users like you!
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.
Have a spare Fios-G1100?Learn how to bridge it into your network
Get Started


Browse Categories

Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.
Modal Dialogue Title