An Accepted Solution is available for this post.
Stand-by Mode in 1.6.2
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Even though the HD DVR is "off", the annoying stand-by message still looms. This is a problem when one uses the presence of a video signal to trigger a receiver to turn on and off. My TV does not have a video out, so I'm forced to use the video out from the HD DVR, which obviously isn't helping me. Anyone else have this issue? Can it be defeated/bypassed?
An Accepted Solution is available for this post.
Re: Stand-by Mode in 1.6.2
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
http://forums.verizon.com/vrzn/board/message?board.id=FiOS_TV&thread.id=9449&page=1
It is discussed in that thread -- its a part of the 1.6.2 upgrade. Unfortunately it always sends that message when the by is turned 'off' -- though technically they are never off so Verizon can shoot updates to the equipment at night. I have yet to hear of anything to bypass it or disable it.