- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ok so I am currently using Verizon's Westell 7500 gateway and am trying to properly setup my Xbox Live. To be more specific I need to set NAT to open. A few months ago I had my NAT set to open properly but after getting the "Red Ring of Death" I sent my Xbox into Microsoft. When I got my Xbox back somehow the settings where changed. I went back and enabled the same thing that set my NAT to open before my Xbox was broken (I believe it was UPnP) however my NAT is still at moderate and I am limited with my abilities on Xbox Live. Anyway, any help is appreciated and if someone can get my NAT back to open I would greatly appreciate it.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
#1 In your router go to Advanced -> IP Address Distribution.
#2 What is the DHCP range of the router?
#3 Is UPnP on in the router ( Advanced -> UPnP ) ?
#4 Are you forwarding the ports manually?
b) If so, what are you forwarding to?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sorry I haven't been on I've been having connection issues.
The DHCP start address is: 192.168.1.15
The DHCP end address is: 192.168.1.47 (I hope that's the range)
UPnP was off, however I just changed it to on.
I did forward my ports manually and the numbers were: 88 UDP, and 3074 UDP and TCP
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That is all to forwarding ( No IP Address to foward to OR for that matter, no device to select ) ?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm confused... what did you say? I'm sorry for my stupidity.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Log-in to the router, and go to the forwarding screen.
Take and post a screen shot of that area..
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I set up my forwarding though the control panel not the router webpage. How do I do that?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@PSU_Fan50 wrote:I set up my forwarding though the control panel not the router webpage. How do I do that?
In the router go to Firewall or Security, and then show a screen shot of that...