Accessibility Resource Center Skip to main content
Have a phone you love? Get up to $500 when you bring your phone.

MI424WR Coax Too Hot To Touch

Copper Contributor
Copper Contributor
Posts: 5
Registered: ‎06-18-2010

MI424WR Coax Too Hot To Touch

Message 1 of 4

Today I went to reset my MI424WR today (because it hadn't been reset in a while and the firewall page had hundreds of UPnP entries) and accidently touched the coax adapter. Normally I wouldn't have even noticed, because as I recall, it never was even warm at all, but this time it was burning hot! Do I need a new router? (Also, this is a revision C.)

Platinum Contributor III
Platinum Contributor III
Posts: 5,881
Registered: ‎07-22-2009

Re: MI424WR Coax Too Hot To Touch

Message 2 of 4

I am pretty sure that it should never be "noticeably hot"   it always gets warm, it's electronics but definetely not "hot"      it is well ventilated right?   


as long as it's well ventilated then you may want to call in for a possible replacement,  warm is ok, but never "hot"

Posts: 2
Registered: ‎08-10-2010

Re: MI424WR Coax Too Hot To Touch

Message 3 of 4

I also have revision C, and today the entire router got so hot that I could barely touch it.  Called Verizon, they said they're sending me a replacement (revision D) immediately.  Apparently they have seen these types of overheating on a monthly basis.  So, I would suggest you call up Verizon and request a replacement.



Gold Contributor VII Gold Contributor VII
Gold Contributor VII
Posts: 2,002
Registered: ‎05-27-2010

Re: MI424WR Coax Too Hot To Touch

Message 4 of 4

Probably good advice ... a general rule of thumb for any properly ventilated consumer grade electronic device is that it should NEVER be too hot to touch (well, unless it's purpose IS to get hot -- like a stove, iron, etc.).   It may get warm or even feel hot, but not so hot as to be painful to touch.   Even improperly ventilated devices shouldn't get that hot -- they all should have a thermal overload protection inside that will kill power to the electronics before a risk of fire develops (and to protect the electronics from frying themselves).

How-To Videos
The following videos were produced by users like you!
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.
Have a spare Fios-G1100?Learn how to bridge it into your network
Get Started


Browse Categories

Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.
Modal Dialogue Title