I have TV service, and need Bridge Mode to get the full features of the Fios TV app working properly, since the Cable Box is sitting on the CR1000A network over COAX, and everything else is on my existing LAN that I set up a while ago.
Cannot figure out how to enable Bridge Mode, or do routes from the 192 subnet (Verizon) to my LAN subnet, which is 10.1.x.x
Looks like previous versions of Fios routers may have had a dedicated bridge mode, but in the user manual for the CR1000A, all I see is mention of turning off DHCP... I'm not sure that's the right answer.
I don't know how new this router is, but anyone else mess with this?
If you have Fios TV One (OR Fios One TV - if I got that wrong), you are required to have Verizon's NAT router handle the public IP Address.
If you have another NAT router, I point to https://forums.verizon.com/t5/g1100-bridging-guide/bd-p/g1100-bridging-guide. While other NAT routers other than from Verion will have a different UI (User Interface), it also applies to these other NAT routers.
Start a new topic or ask questions in the open forum.
