- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just purchased a new Pioneer receiver and was programming my Verizon remote. I replaced an older Pioneer receiver, so I have had this working correctly before.
After programming my remote AUX button to the receiver, I can control the volume on the receiver using the remote. However, unless I press the TV button, I have no control over the DVR. Also, somehow the STB button got programmed to control the TV and not the DVR.
Previously, I was able to control the volume on the receiver and use all of the DVR controls without having to use the device controls on top of the remote (DVD/AUX/TV/STB).
Is there a way to clear all of the programming on the remote so I can start from scratch?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
stb + ok (two seconds) code is 900 to clear the programming.
Philips RC 1445302 Remote
Instructions and Help for the Philips RC 1445302 Remote No remote code listed for my device Existing remote codes don't work Set up your remote to turn on/off multiple devices Troubleshooting your Remote
Set up (without Guide) |