Accessibility Resource Center Skip to main content
Get up to $500 when you bring your phone. Plus, get the incredible iPhone 13 Pro on us. Online only. With select 5G Unlimited plans. Ends 12.5. Buy now
end of navigation menu

Searching for signal when changing channels

Reply
pfdg3
Nickel Contributor
Nickel Contributor
Posts: 37
Registered: ‎11-05-2011

Searching for signal when changing channels

Message 1 of 2
(768 Views)

I have a Cisco 435 that nearly always has a delay when changing channels, searching for a signal for a second or two in between. I tried rebooting and "Fix Fios TV Issues".

 

This started a few weeks ago.

 

1 REPLY 1
CRobGauth
Platinum Contributor III Platinum Contributor III
Platinum Contributor III
Posts: 8,010
Registered: ‎11-04-2008

Re: Searching for signal when changing channels

Message 2 of 2
(736 Views)

DO you have more than 1 box?

If so, does it happen on all or just the one?

If it is only one of several, then try swapping them around to see if problem follows box or connection.

If it is all, then start at ONT.

Make sure all coax connections are tight.


If a forum member gives an answer you like, give them the Kudos they deserve. If a member gives you the answer to your question, mark the answer as Accepted Solution so others can see the solution to the problem.
How-To Videos
 
The following videos were produced by users like you!
   
Videos are subject to the Verizon Fios Community Terms of Service and User Guidelines and contains content that is not created by Verizon.
Have a spare Fios-G1100?Learn how to bridge it into your network
Get Started


Covid19

Browse Categories
Categories:
Posts

Verizon Troubleshooters
Unable to find your answer here? Try searching Verizon Troubleshooters for more options.
Modal Dialogue Title